|
 Hydraulic
tilt & trim with no castings or welds to break. Don't settle for
less quality imitations!
Save
your back from stress with the new PT-35. The PT-35 is a
lighter, more compact Tilt and Trim unit manufactured for 35
horsepower motors and smaller (Down to 2 H.P.). This unit is
11-1/2 inches wide and weighs only 24 lbs! The PT-35 utilizes
the same hydraulic actuator as the PT-130 and gives you all the
same benefits. This unit easily adapts to bolt-on motors and
clamp-on motors (*within the 11 inch frame) without the need of
an adapter.
 Experience
Convenience & Improved Performance
The
PT-35 incorporates a 5 1/2 inch setback, which enhances boat
stability and enables the prop to get a better "bite" at a
higher prop setting. With the touch of a switch you can raise
your motor to protect your prop from damage and your back from
strain. It has a total of 84 degrees of trim and tilt. It allows
you to tuck your motor in to get your boat on plane smoother and
faster. When you're underway, you can change the angle of your
motor to obtain the best performance for your load and water
conditions. It gives you a more stable ride, increases top end
speed, more prop clearance and better fuel efficiency.
 IMPORTANT
*The
inside dimensions of the motor mounting area of the PT-35 is 11
inches. Before ordering, please make sure that the maximum
width of the clamp mounting feet and/or mounting bolts of the
motor that must fit in this area does not exceed this 11 inch
limit.
|
