PowrTran Tilt and Trim PTT50 6300 Max 50HP
Pow rTran Power Tilt & Trim units unlock the hidden performance potential in boats and motors. Our power trim and tilt features advanced engineering with a combination of features. The PowrTran is like a transom bracket and power trim and tilt all combined into one superior unit. It not only enhances top end speed, but also reduces fuel consumption, improves hole shots, stabilizes boat ride and tracking, and eliminates most plowing, porpoising and chinewalking. The PowrTran Power Tilt & Trim has full power all the way up, and will not kick down from propeller force at any degree of trim.
The Pow'rTran Power Tilt & Trim is ideal for most boats, including pontoons. Best of all, PowrTran PT&T units are very economical. They cost less than most factory units and are easier, faster and less expensive to repair than factory hydraulic units. Simply put, the Pow'rTran PT&T has no equal.
Should service be necessary the actuator is removed in minutes by removing two clevis pins and unplugging the electrical cord. Just place the clevis pin in the hole in the lower port side of the PTT frame and continue boating.
The Powertran PTT50 (formally known as the PTT60PSS) Tilt & Trim is designed for clamp-on motors.
We recommend you check the size of your motor mounting plate and compare it with the specifications listed below. If your motor requires a larger mounting area please check out our PTT130 Part# 6100
Specifications:
Max Horsepower: 50
Unit Weight: 40 lbs.
Mounting Footprint: 14 H x 15 W
Engine Mounting Plate: 14 H x 13 W
Lift Speed Lock to Lock: 7.2 seconds
Power requirements: 12 V
Operation: 12 Volt Electro- Mechanical
Operation: Ball Screw Actuator
Construction: Aluminum
Controls: Standard 2-Button Switch w/16ft of cable (Longer cables can be purchased for special applications)
